Различия

Показаны различия между двумя версиями страницы.

--- en:documentation:commandexec [2013/02/04 15:58] – loopback
+++ en:documentation:commandexec [2020/04/05 14:41] (текущий) – loopback
@@ Строка 2: / Строка 2: @@
 <code>
-CommandExec [/CD[:T|S|TS]] <command/path1> [<path2>]
+CommandExec <command> [<params>]
+CommandExec /CD[:{T|S|TS}] <path1> [<path2>]
 </code>
 Execute user command em_* or set a paths in the panels.
-**Parameters**
+**Parameters for executing internal command**
 |< 100% 15% >|
-|command/path1|In case of executing TC's internal command, this parameter must be set to the name of a user command (usually prefixed with em_).\\ If case of setting paths, this parameter must contain the first path.|
+|command|Must be set to the name of a user command (usually prefixed with em_).|
-|path2|If case of setting paths, this parameter must contain the second path.|
+|params|Must contain the parameters of em-command.|
+**Parameters for setting paths**
+|< 100% 15% >|
+|path1|This parameter must contain the first path.|
+|path2|This parameter must contain the second path.|
 **Switches**
 |< 100% 15% >|
-|**[/CD]**|Setting this switch allow to set paths in the Total Commander panels. First and optional second parameters - paths for setting in panels. After parameter can be optional flags how to set paths:\\ **T** - open in new tab,\\ **S** - make first path as source, second as target, else left and right panels  accordingly,\\ **ST** - combination of parameters.|
+|**[/CD]**|Setting this switch allow to set paths in the Total Commander panels. First and optional second parameters --- paths for setting in panels. After parameter can be optional flags how to set paths:\\ **T** --- open in new tab,\\ **S** --- make first path as source, second as target, else left and right panels  accordingly,\\ **ST** --- combination of parameters.|
+**Examples**
+<code>
+# opens the configuration dialog
+CommandExec cm_Config
+# execute the user command "em_UserCommand1"
+CommandExec em_UserCommand1
+# opens "C:\Windows" path in the left panel
+CommandExec /CD "C:\Windows"
+# opens "C:\Windows" path in the right panel (note first parameter is empty)
+CommandExec /CD "" "C:\Windows"
+# opens "C:\Windows" path in new tab in the left panel
+CommandExec /CD:T "C:\Windows"
+# opens "C:\Windows" path in the source panel, "D:\Test" in the target panel
+CommandExec /CD:S "C:\Windows" "D:\Test"
+# opens "C:\Windows" path in the new tab of source panel,
+# "D:\Test" in the new tab of target panel
+CommandExec /CD:ST "C:\Windows" "D:\Test"
+</code>